Cancelling common-mode voltage with amplifier

Article By : Stephen Woodward

Find out how to eliminate common-mode-voltage errors with this amplifier circuit that subtracts out the error.

Since the dawn of time—or at least since the dawn of precision electronics—analogue designers has always been troubled by common-mode-voltage (CMV)-induced errors, also known as the dreaded ground loop. Although almost mystical is the fear it strikes in the hearts of engineers, there's nothing particularly mysterious about CMV. CMV errors occur for a simple reason: The common voltage references—that is, ground—of circuitry in different places, such as sensors in one chassis and an ADC in another, are apt to differ. Therefore, when you route signals between remotely located circuits, the CMV differential appears as additive noise and offset, corrupting the desired signals.
Many approaches exist for eliminating CMV errors. These methods include the brute-force approach of using massive amounts of copper in ground interconnections, fully differential instrumentation-amplifier signal conditioners, and galvanic isolators. Each has its place, depending on such factors as the severity of the CMV problem and the number of signal channels needing CMV remediation. One of the most popular and effective CMV remedies is differential amplification, in which you perform an analogue subtraction to remove the CMV component from the signal. The downside of this method is that it requires a dedicated amplifier for every signal channel. The circuit in the figure is a variation on that same differential-amplifier idea, but it combines two shared CMV amplifiers with simple passive-resistor pairs among eight multiplexed channels to provide CMV cancellation for a large number of analogue channels at minimum component count.

[EDNAOL 2017JUN07 AN 02Fig]*Figure: Amplifier A1 amplifies and inverts the common-mode voltage by a factor of 110. Then, the circuit applies this signal to an array of passive summation networks. An analogue multiplexer selects the desired input signal, and op amp A2 supplies a compensating gain.*

Here's how it works. Amplifier A1 amplifies and inverts the CMV by a factor of –10. You then apply this CMV to an array of passive-summation networks—one for each input signal. The 10-to-1 ratio of the two legs of each network combines the incoming input-voltage and CMV signals with the –10V CMV ground-noise reference: V=10/11×(VI+VCM) +1/11×(10×VCM)=10/11×VI+10/11×(VCM–VCM)=10/11×VI. VCM is attenuated by a factor depending mainly on the accuracy of 20- versus 2-kΩ resistor-ratio matching. For 1% matching, the CMRR (common-mode-rejection ratio) is approximately 100-to-1, or 40 dB; for 0.1% matching, CMRR is 1000-to-1, or 60 dB.
The analogue multiplexer then selects the desired input voltage for input to the 11/10 scale-factor-correction amplifier, A2. The optional 0.1-µF filter capacitors provide a modicum of lowpass noise filtering, and you should tailor them for the bandpass requirements of your application. The approximately 180µsec, or approximately 88Hz, is too slow for many applications and too fast for others.

This article is a Design Idea selected for re-publication by the editors. It was first published on May 10, 2007 in

Subscribe to Newsletter

Leave a comment