Practical RTD interface solutions
|
2007-08-01 |
| This application note is intended to review RTD and commonly used interfaces for them. In an industrial environment, longitudinal noise in a wide spectrum may exist requiring good common mode rejection at the circuit interface |
|
CAT51DB1 digitally programmable potentiometer (DPP) demonstration board with incremental up/down interface
|
2008-05-28 |
| This document by enisa Stefan describes the CAT51DB1 evaluation/demonstration board for Catalyst DPP ICs with an increment up/down interface |
|
Switching power supply design with the PIC16F785
|
2008-03-07 |
| In this application note, we will examine a typical buck topology intelligent switching mode power supply design using the PIC16F785 |
|
Design and programming examples for lighting management unit LP5526
|
2007-09-24 |
| This document provides information for customers who are using LP5526. The document is written to help design, layout and software engineers reduce the time needed for successful design |
|
Micron ECC module for NAND flash via Xilinx Spartan-3 FPGA
|
2008-05-13 |
| This technical note describes the features of the Micron NAND Flash ECC module and how it calculates and implements ECC. |
|
Booting from embedded MMC
|
2008-05-15 |
| This technical note describes booting from an embedded MMC device#8212;such as Micron's Managed NAND#8212;and provides supporting documentation for designers incorporating MMCs in their applications. |
|
USB 2.0 board design and layout guidelines
|
2008-04-25 |
| This application note from Texas Instruments discusses schematic guidelines when designing a universal serial bus system. |
|
Using Micron asynchronous PSRAM with ADI ADSP-BF53x Blackfin processors
|
2008-02-19 |
| This technical note describes the design requirements for a seamless memory connection between Blackfin processors and Micron 70ns, 8Mbit asynchronous PSRAM devices |
|
| Design guidelines for implementing external memory interfaces in Stratix II and Stratix II GX devices
|
2007-03-05 |
| Stratix II offers support for double data rate (DDR) memories, such as DDR2/DDR SDRAM, QDRII+/QDRII SRAM, and RLDRAM II interfaces. Applications with these memory interfaces include PCs, embedded processing, image processing, storage, communications, and networking. |
|
Current-sensing power MOSFETs
|
2008-05-08 |
| Vishay Siliconix current-sensing power MOSFETs offer a simple means of incorporating a protection feature into an electronic control circuit and avoiding catastrophic failures resulting from overcurrent (overload) and/or short-circuit conditions. |
|
A detailed guide to powering the TigerSHARC processors
|
2008-05-26 |
| This application note from Analog Devices discusses the voltage regulators/switchers that are suitable for processors running at 600MHz. |
|
Implementing DDR2 PCB layout on the TMS320DM646x DSP
|
2008-06-20 |
| This application report from Texas Instruments contains implementation instructions for the DDR2 interface contained on the TMS320DM646x DSP device. The approach to specifying interface timing for the DDR2 interface is quite different than on previous devices |
|
Implementing DDR2 PCB layout on the TMS320DM646x (Rev. A)
|
2008-04-25 |
| This document contains implementation instructions for the DDR2 memory controller interface contained in the TMS320DM646x DSP devices. The approach to specifying interface timing for the DDR2 interface is quite different than on previous devices |
|
USB device stack for PIC32 programmer's guide
|
2008-04-29 |
| This application note describes the Microchip PIC32 USB peripheral firmware stack and acts as a programmer's reference manual for developers who need to design firmware for any type of USB peripheral device for which no Microchip sample implementation is available |
|
USB mass storage class on an embedded device
|
2008-03-24 |
| This application note discusses and provides a mass storage device function driver that can be integrated with almost any application running on Microchip 32bit PIC MCU products with USB peripheral support. |
|