Transform a DC/DC Converter into a High Performance, Full-Featured Battery Charger
Would you like to learn how to Transform a DC/DC Converter into a High Performance, Full-Featured Battery Charger? --- Click here to watch the video.
Would you like to learn how to Transform a DC/DC Converter into a High Performance, Full-Featured Battery Charger? --- Click here to watch the video.
|
Highest-performing AFEs for superior ultrasound 1.CW mode for blood flow velocity 2.Best power/noise performance 3.Best image quality -->Order samples |
Application Notes (Sorted By Date)
- Clocking High-Speed A/D Converters (2007-02-27)
- Noise, TDMA Noise, and Suppression Techniques (2007-02-27)
- Single Supply Operation of the DAC0800 and DAC0802 (2007-02-27)
- An Introduction to Transient Voltage Suppression Devices (2007-02-26)
- Applications for the NE521/522 (2007-02-26)
- Audio Circuits Using the NE5532/34 (2007-02-26)
- Avalanche TVS Diode SPICE Macro-Models (2007-02-26)
- Introduction to Analog Video (2007-02-26)
- Compandor Application Automatic Gain Control (2007-02-26)
- Power amplifier theory for high-efficiency, low-cost ISM band transmitters (2007-02-19)
- 3823 Group: A/D converter (internal trigger) (2007-02-05)
- A/D conversion in scan mode (2007-02-05)
- Combination of DMAC and serial interface transmission (2007-02-05)
- Output of three-phase PWM signals and the corresponding inverse signals (2007-02-05)
- A/D conversion control of the 7542 group (2007-02-05)
- Application of A/D converter (single A/D conversion mode) (2007-02-05)
- Analog ICs for Low Voltage Systems (2006-12-01)
-
VFA, CFA, Bipolar or CMOS - Which high-speed amplifier is best for your low-noise application?
(2006-06-02)
-
LDMOS transistors bias control in basestation RF power amplifiers using Intersil's LUT-based sensor signal conditioners
(2006-06-02)
-
ISL6558EVAL2: Low-profile, 5V/12V input, 500kHz and 90 percent efficiency DC/DC converter
(2006-06-02)
-
Thermal stability of MOSFETs
(2005-06-23)
-
Low-side self-protected MOSFET
(2005-06-23)
-
NIS5101 troubleshooting guide
(2005-06-23)
-
Design considerations for ESD/EMI filters: I
(2005-06-23)
-
100W universal input PFC boost using NCP1601A
(2005-06-22)
-
Non-isolated positive output buck/boost ac-dc converter
(2005-06-22)
-
Non-isolated negative output buck ac/dc converter
(2005-06-22)
-
A 75W TV power supply operating in quasi-square wave resonant mode using the NCP1207 controller
(2005-06-21)
-
Offline LED driver
(2005-06-21)
-
Performance improvements to the NCP1012 evaluation board
(2005-06-21)
-
Thermal analysis and reliability of wire bonded ECL
(2005-06-21)
-
Implementing NCP1207 in QR 24W ac-dc converter with synchronous rectifier
(2005-06-21)
-
Design of a 100W dc-dc converter for telecom systems using the NCP1560
(2005-06-21)
-
Designing converters with the NCP101X family
(2005-06-21)
-
Options for lowering the capacitance in TSPD devices
(2005-06-20)
-
Conducted EMI filter design for the NCP1200
(2005-06-20)
-
Designing a boost-switching regulator with the MCP1650
(2005-06-17)
-
Simple synchronous buck converter design - MCP1612
(2005-06-16)
-
F2810, F2811, and F2812 ADC calibration
(2005-06-15)
-
Extended output voltage adjustment (0V to 3.5V) using the TI TPS5210
(2005-06-14)
-
Simple design of an ultra-low-ripple dc/dc boost converter with TPS60100 charge pump
(2005-06-14)
-
Advantages of using PMOS-type low-dropout linear regulators in battery applications
(2005-06-14)
-
Frequency response errors in voltage feedback op amps
(2005-06-14)
-
Power supply solutions for TI DSPs using synchronous buck converters
(2005-06-14)
-
Comparison of different power supplies for portable DSP solutions working from a single-cell battery
(2005-06-14)
-
Synchronous buck regulator design using the TI TPS5211 high-frequency hysteretic controller
(2005-06-14)
-
Stability analysis of low-dropout linear regulators with a PMOS pass element
(2005-06-14)
-
Understanding the stable range of equivalent series resistance of an LDO regulator
(2005-06-14)
-
Understanding the load-transient response of LDOs
(2005-06-14)
-
Comparing magnetic and piezoelectric transformer approaches in CCFL applications
(2005-06-13)
Top10 Article
- Research center targets home energy conservation
- Nvidia resigns from PC benchmarking consortium
- AMD quits BAPCo, disputes benchmarking standards
- Multitest reports growing contactor shipments
- Iwatsu to produce curve tracers for Cascade Microtech
- NERF research unravels neuronal circuits
- TowerJazz joins R&D project in Argentina
- NTAF rolls new network spec
- Sono-Tek expands customer service with new labs
Most Popular
Resource Center
- [Keithley] Keithley Precision DC I-V, AC Impedance, and Ultra-fast or Transient I-V MeasurementsNEW!
- [Keithley] Measuring Inductance Using the 4200-CVU Capacitance-Voltage Unit Hot!
- [Keithley] DC Power Supply Information Kit
- [Keithley] Keithley Model 4200-SCS Semiconductor Characterization System Technical Data
- [Keithley] How to Select the Right Temperature SensorNEW!
- [Keithley] Expand your device characterization with Ultra-Fast I-V testingHot!
- [Keithley] Fundamentals of Semiconductor C-V Measurements
- [Keithley] Switch and Control Solutions for DC, RF and Light
Search EE Times Asia
Top Ranked Articles
- Electronics trends in Asia: Opportunities and challenges
- CES Unveiled: A gadget haven
- New 28nm platforms: Transforming Asia from world's factory to global R&D hub
- Power amp fit Wi-Fi, WiMAX apps
- Power amps simplify 3G handset design
- Op amps equipped with power-saving features
- Integrated EMI filter handles high-speed data line apps
- DAC/amp enhances audio quality in mobile apps
- Power amp geared for mobile WiMAX systems
- I²C digipots deliver increased accuracy, reliability
