|
|||||||||
|
|||||||||
|
|||||||||
Bits and bytes
PolyPhase® DC/DC Converters
See the latest episode of the Linear Video series. Click here to learn the differences between voltage mode and current mode control in a PolyPhase® DC/DC Converter.
See the latest episode of the Linear Video series. Click here to learn the differences between voltage mode and current mode control in a PolyPhase® DC/DC Converter.
Application Notes (Sorted By Date)
- Audio Circuits Using the NE5532/34 (2007-02-26)
- Introduction to Analog Video (2007-02-26)
- Compandor Application Automatic Gain Control (2007-02-26)
- Power amplifier theory for high-efficiency, low-cost ISM band transmitters (2007-02-19)
- 3823 Group: A/D converter (internal trigger) (2007-02-05)
- A/D conversion in scan mode (2007-02-05)
- Combination of DMAC and serial interface transmission (2007-02-05)
- Output of three-phase PWM signals and the corresponding inverse signals (2007-02-05)
- A/D conversion control of the 7542 group (2007-02-05)
- Application of A/D converter (single A/D conversion mode) (2007-02-05)
- Analog ICs for Low Voltage Systems (2006-12-01)
-
VFA, CFA, Bipolar or CMOS - Which high-speed amplifier is best for your low-noise application?
(2006-06-02)
-
LDMOS transistors bias control in basestation RF power amplifiers using Intersil's LUT-based sensor signal conditioners
(2006-06-02)
-
ISL6558EVAL2: Low-profile, 5V/12V input, 500kHz and 90 percent efficiency DC/DC converter
(2006-06-02)
-
Non-isolated positive output buck/boost ac-dc converter
(2005-06-22)
-
Non-isolated negative output buck ac/dc converter
(2005-06-22)
-
Implementing NCP1207 in QR 24W ac-dc converter with synchronous rectifier
(2005-06-21)
-
Design of a 100W dc-dc converter for telecom systems using the NCP1560
(2005-06-21)
-
Designing converters with the NCP101X family
(2005-06-21)
-
Designing a boost-switching regulator with the MCP1650
(2005-06-17)
-
Simple synchronous buck converter design - MCP1612
(2005-06-16)
-
F2810, F2811, and F2812 ADC calibration
(2005-06-15)
-
Extended output voltage adjustment (0V to 3.5V) using the TI TPS5210
(2005-06-14)
-
Simple design of an ultra-low-ripple dc/dc boost converter with TPS60100 charge pump
(2005-06-14)
-
Advantages of using PMOS-type low-dropout linear regulators in battery applications
(2005-06-14)
-
Frequency response errors in voltage feedback op amps
(2005-06-14)
-
Power supply solutions for TI DSPs using synchronous buck converters
(2005-06-14)
-
Comparison of different power supplies for portable DSP solutions working from a single-cell battery
(2005-06-14)
-
Synchronous buck regulator design using the TI TPS5211 high-frequency hysteretic controller
(2005-06-14)
-
Stability analysis of low-dropout linear regulators with a PMOS pass element
(2005-06-14)
-
Understanding the stable range of equivalent series resistance of an LDO regulator
(2005-06-14)
-
Understanding the load-transient response of LDOs
(2005-06-14)
-
Comparing magnetic and piezoelectric transformer approaches in CCFL applications
(2005-06-13)
-
Understanding piezoelectric transformers in CCFL backlight applications
(2005-06-13)
-
Pressure transducer-to-ADC application
(2005-06-13)
-
Fully differential amplifiers applications: Line termination, driving high-speed ADCs, and differential transmission lines
(2005-06-13)
-
Optimal design for an interleaved synchronous buck converter under highslew- rate, load-current transient conditions
(2005-06-13)
-
App Note 3512: Spread-spectrum clock oscillators lower EMI
(2005-06-08)
-
Schematic and layout guidelines for high-speed data converters
(2005-06-08)
-
Driving strain-gauge bridge sensors with signal-conditioning ICs
(2005-06-06)
-
Understanding the effects of clock tolerances on 50/60Hz noise rejection in high-performance Sigma Delta ADCs
(2005-06-06)
-
Using the MAX6650 and MAX6651 fan speed regulators with 24V and 48V fans
(2005-06-06)
-
Injection transformers for closed-loop dc/dc converter network analysis
(2005-06-06)
-
Using the ISL6420 PWM controller evaluation board
(2005-06-03)
-
Remotely adjustable voltage regulators using XDCPs
(2005-06-03)
-
Expanding the number of DAC outputs on the ADuC8xx and ADuC702x families
(2005-06-01)
-
Sampled systems and the effects of clock phase noise and jitter
(2005-06-01)
-
Set-Up and hold measurements in high-speed CMOS Input DACs
(2005-06-01)
-
Cellular system solutions for NFC-enabled handsets
(2005-02-01)
-
SiGe direct modulator for multiband upconversion
(2005-02-01)
|
|||||||||||||||
|
|||||||||||||||
 |
10 Most Popular Datasheets
Resource Center
- [Avago] Solutions for Mobile Information Appliances
- [Cypress] Interfacing the QDR(TM) to the XILINX SPARTAN-II FPGA
- [NI] Reduce Costs and Development Time for Embedded System Design
- [ADI] Designing with Switching Regulators in High-Speed A/D Converter Applications
- [Cypress] Embedded Change Just Happens!
- [ADI] The Basics of Video Decoders in Supervision and Inspection
- [NI] Reduce Costs for OEM Solutions
- [ADI] Precision ADC Selection Guide
- [Cypress] PSoC(R) Programmable System-on-Chip Technical Reference Manual (TRM)
- [Cypress] New PSoC Platform
Top Ranked Articles
- SiGe mixer enables cost-effective filter designs
- Rail-to-rail op amps boast 180MHz at 1mA
- Royalty-free codecs enable low-cost HD VoIP
- ADCs offer resolution, channel count flexibility
- Wolfson builds R&D center in Yokohama
- Op amps enable accurate medical devices
- Integrated solutions make analog filter design easy
- Ultra-linear, push-pull amps tailored for CATVs
- SoC simplifies full-HD multimedia display design
- Crystal oscillator offers dual-output-frequency
